Rhinoceros 5.18 [control points]

“Manipulating control points”


There is content on this page that is restricted to members. You must login to view this premium content.
If you are not yet a member, click here to learn about becoming a member.
  1. You can manipulate the control points of any object in Rhinoceros.
  2. Type “PointsOn” then select the object you wish to edit by control points.
  3. You will see control points appear at the corners (and on top of) surfaces, meshes & curves.
  4. You can manipulate the control points in a variety of ways.
    • Use the “move” command to move control points with a base point (remember your object snaps).
    • Simply click on the control point and drag to move/adjust it.

Downloads:

Comments (0)

Submit a comment... (Minimum 25 characters)