Unrolling Surfaces
Lecture 217 · Terrain & fabrication
Preparing .dwg files for laser cutting and .stl/gcode files for 3D printing
Watch the lecture
This is the recording linked first on the preserved 2021 source page. It opens separately.
Open the source recording on YouTubeExternal link from source page 272107. The recording opens separately on YouTube.
Read alongside the recording
Lecture notes
The source page contains a recording but no written lecture-notes section. No written lesson has been invented; older recording lists and supporting resource controls are omitted.
Recording-led lecture · Sparse source notesAbout this source
Source page 272107, dated 2021-10-18. This is the newest published page found for this lecture number in the preserved source. Earlier semester copies are not new lessons. The layout has been adapted for reading; slide downloads and repeated recording lists are not included.